Thanks,
that's what I actually thought when reading those debug printouts, but ending closure was just soo scary. Yes, it did nothing and computer works as before.
// Sami
On 2022-10-15 23:16, Angel Pons wrote:
Hi Sami,
On Sat, Oct 15, 2022 at 7:44 PM Sami via flashrom flashrom@flashrom.org wrote:
Is there anything I can do anymore?
See in-line messages.
// Sami
flashrom --programmer internal --ifd -i bios --noverify-all -w Z87A.bin flashrom v1.2 on Linux 5.10.0-18-amd64 (x86_64) flashrom is free software, get the source code at https://flashrom.org
Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns). Found chipset "Intel Z87". Enabling flash write... Warning: BIOS region SMM protection is enabled! Warning: Setting Bios Control at 0xdc from 0x2a to 0x09 failed. New value is 0x2a.
This means your mainboard's BIOS/UEFI firmware restricts write access to the flash chip. Enabling writes failed.
SPI Configuration is locked down. FREG0: Flash Descriptor region (0x00000000-0x00000fff) is read-only. FREG2: Management Engine region (0x00001000-0x0017ffff) is locked. Not all flash regions are freely accessible by flashrom. This is most likely due to an active ME. Please see https://flashrom.org/ME for details. At least some flash regions are read protected. You have to use a flash layout and include only accessible regions. For write operations, you'll additionally need the --noverify-all switch. See manpage for more details.
This means some part of the flash chip (the ME region) cannot be read.
OK. Found Winbond flash chip "W25Q64.V" (8192 kB, SPI) mapped at physical address 0x00000000ff800000. Reading ich descriptor... done. Using region: "bios". Reading old flash chip contents... done. Erasing and writing flash chip... Transaction error! spi_write_cmd failed during command execution at address 0x180000 Reading current flash chip contents... done. Looking for another erase function. spi_write_cmd failed during command execution at address 0x180000 Reading current flash chip contents... done. Looking for another erase function. spi_write_cmd failed during command execution at address 0x180000 Reading current flash chip contents... done. Looking for another erase function. Transaction error! Can't read! Aborting.
This is because the ME region is not readable. Why flashrom still tries to read it anyway is rather puzzling.
FAILED! Uh oh. Erase/write failed. Your flash chip is in an unknown state.
This is because flashrom could not read the ME region, and could not check whether the flash chip contents have changed. However, we know that SMM BIOS write protection is enabled, which prevents flashrom from writing to the flash chip. So, flashrom couldn't have modified the flash chip contents.
Get help on IRC at chat.freenode.net (channel #flashrom) or mail flashrom@flashrom.org with the subject "FAILED: <your board name>"!
DO NOT REBOOT OR POWEROFF!
Based on the reasonings given earlier, it should be safe to reboot because flashrom couldn't have possibly changed the flash chip contents.
flashrom mailing list -- flashrom@flashrom.org To unsubscribe send an email to flashrom-leave@flashrom.org
Best regards, Angel