Hello,
I'm having some problems flashing a SPI chip with the BusPirate V3. Writing the image is successful but verification is not successful.
First try with chip on breadboard and long leads (20-25cm): http://paste.flashrom.org/view.php?id=2841
Then I shortened the signal leads and soldered them directly on the BusPirate: http://paste.flashrom.org/view.php?id=2842
Then I soldered all leads directly on the chip (with an adapter) instead of using a breadboard: http://paste.flashrom.org/view.php?id=2844
I also tried lowering the SPI speed to 1 MHz: http://paste.flashrom.org/view.php?id=2845
Current set-up [image: Inline afbeelding 1] [image: Inline afbeelding 2]
Chip datasheet: http://www.farnell.com/datasheets/1674442.pdf Flash connected in this way: http://flashrom.org/Bus_Pirate
Is there anything else I can try or should I try replacing the flash chip?
Kind regards, Ruben Van de Put
