Hi Mike!
I've followed the linked guide, it gave me these results. The grounds are united, still the same error happens. I have tried to GND pin 42 of KB9012 as mentioned in the guide, and tried to connect both pin 41 and 42 to GND, as in KBC's datasheet at EDI related part, still no success, flashrom doesn't detect it.
Mike Banon mikebdp2@gmail.com ezt írta (időpont: 2019. jan. 8., K, 16:08):
Hi Nyulos, Have you tried following the KB9012 flashing instructions at DangerousPrototypes wiki? http://dangerousprototypes.com/docs/Flashing_KB9012_with_Bus_Pirate Although that is for Bus Pirate / CH341A programmers and LA-A091P, should be similar for your Rayer programmer and LA-8241P motherboard. Most importantly, before plugging the power adapter you should unite three grounds:
- GND of laptop's motherboard
- GND of your programmer
- GND of KB9012
Best regards, Mike Banon
On Tue, Jan 8, 2019 at 3:30 PM Nyúlós Lónyál udpsendtofailed@gmail.com wrote:
Hi!
I'm trying to flash an ENE KB9012QF A3 KBC on LA-8241P motherboard. The
problem is flashrom can't detect the internal SPI of it, fails with error.
flashrom p1.0-141-g9cecc7e on Linux 4.15.0-20-generic (x86_64) flashrom is free software, get the source code at https://flashrom.org
flashrom was built with libpci 3.5.2, GCC 7.3.0, little endian Command line (5 args): ./flashrom -p rayer_spi -c KB9012 (EDI) -V Using clock_gettime for delay loops (clk_id: 1, resolution: 1ns). Initializing rayer_spi programmer Using address 0x378 as I/O base for parallel port access. Using RayeR SPIPGM pinout. The following protocols are supported: SPI. Probing for ENE KB9012 (EDI), 128 kB: edi_chip_probe: reading hwversion
failed
No EEPROM/flash device found. Note: flashrom can never write if the flash chip isn't found
automatically.
How to get it working? Thanks a lot for help! _______________________________________________ flashrom mailing list -- flashrom@flashrom.org To unsubscribe send an email to flashrom-leave@flashrom.org