Dear Marek,
Am Freitag, den 26.11.2010, 21:40 +0100 schrieb Marek Zakrzewski:
flashrom v0.9.2-r1001 on Linux 2.6.34.6-xxxx-std-ipv6-64 (x86_64), built with libpci 2.2.3, GCC 4.1.2 20080704 (Red Hat 4.1.2-48)
flashrom is free software, get the source code at http://www.flashrom.org
Initializing internal programmer
No coreboot table found.
dmidecode execution unsucessfull - continuing without DMI info
Found ITE Super I/O, id 8712
Found chipset "NVIDIA MCP78S", enabling flash write... This chipset is not really supported yet. Guesswork...
ISA/LPC bridge reg 0x8a contents: 0x40, bit 6 is 1, bit 5 is 0
Guessed flash bus type is SPI
Found SMBus device 10de:0752 at 00:01:1
SPI BAR is at 0xfcf80000, after clearing low bits BAR is at 0xfcf80000
SPI control is 0xc01a, enable=0, idle=0
Please send the output of "flashrom -V" to flashrom@flashrom.org to help us finish support for your chipset. Thanks.
SPI on this chipset is not supported yet.
OK.
This chipset supports the following protocols: None.
SuperI/O ID 8712 is not on the controller list.
Calibrating delay loop... 1397M loops per second, 10 myus = 11 us, 100 myus = 101 us, 1000 myus = 998 us, 10000 myus = 10030 us, OK.
[…]
No EEPROM/flash device found.
Note: flashrom can never write if the flash chip isn't found automatically.
The version of flashrom you used r1001 is outdated. Please try version 0.9.3 or preferably the latest from the repository [1].
Thanks,
Paul
PS: Please send just plain text messages and no HTML formatted messages to mailing lists (see for example [2]).
[1] http://flashrom.org/Downloads [2] http://it.opensuse.org/OpenSUSE_mailing_list_netiquette#Do_not_use_HTML