Hi Carl-Daniel
I got the 9.1 version from Ubuntu Synaptic.
I went to your website and downloaded flashrom-0.9.4.tar.bz2. I copied file to /home/barry
in Terminal I did $ tar jxf /home/barry/flashrom-0.9.4.tar.bz2
This created /home/barry/flashrom-0.9.4 directory
I then did
cd /home/barry/flashrom-0.9.4
then
# ./configure # make # make install
These commands executed with no messages.
When i do command flashrom -R I still see version 9.1.
Any suggestions?
Thanks
Barry
On Sun, Dec 11, 2011 at 8:54 PM, Carl-Daniel Hailfinger < c-d.hailfinger.devel.2006@gmx.net> wrote:
Hi Barry,
it seems you're using a very old flashrom version. Could you please retry with latest flashrom or at least version 0.9.4? That might fix the issue you're seeing.
Am 12.12.2011 01:19 schrieb Barry Krauter:
Attempting to replace currbios with 661VS155.BIN upgraded Bios for
Shuttle
661V31 motherboard using 3com NIC card.
Can you tell me why this fails?
barry@baerry-desktop:~$ sudo flashrom -p nic3com -w
/home/barry/661VS155.BIN
flashrom v0.9.1-r946 Found "3COM 3C90xB: PCI 10/100 Mbps; shared 10BASE-T/100BASE-TX"
(10b7:9055, BDF 06:02.0).
Calibrating delay loop... OK. Found chip "SST SST39SF020A" (256 KB, Parallel) at physical address
0xfffc0000.
That flash chip is marked as supported in latest flashrom.
Regards, Carl-Daniel