Hi, I'm trying to flash libreboot to my x200 using a Shikra. When it gets to the "Erasing and writing flash chip" part, it seems to hang, but top shows that flashrom is still using a lot of the CPU. I left it for over 3 hours and it doesn't get any further than my logfile below. Would anyone be able to shed some light as to what might be going on here? Thanks.
command: flashrom -p ft2232_spi:type=232H -c "MX25L6405D" -w x200_8mb_usqwerty_vesafb.rom -V 2>&1 | tee logfile
output: flashrom v0.9.8-r1889 on Linux 3.17.4-301.fc21.x86_64 (x86_64) flashrom is free software, get the source code at http://www.flashrom.org
flashrom was built with libpci 3.3.0, GCC 4.9.2 20150212 (Red Hat 4.9.2-6), little endian Command line (7 args): flashrom -p ft2232_spi:type=232H -c MX25L6405D -w x200_8mb_usqwerty_vesafb.rom -V Calibrating delay loop... OS timer resolution is 1 usecs, 1491M loops per second, 10 myus = 10 us, 100 myus = 119 us, 1000 myus = 1019 us, 10000 myus = 10100 us, 4 myus = 4 us, OK. Initializing ft2232_spi programmer Using device type FTDI FT232H channel A. Disable divide-by-5 front stage Set clock divisor MPSSE clock: 60.000000 MHz, divisor: 2, SPI clock: 30.000000 MHz No loopback of TDI/DO TDO/DI Set data bits The following protocols are supported: SPI. Probing for Macronix MX25L6405D, 8192 kB: probe_spi_rdid_generic: id1 0xc2, id2 0x2017 Found Macronix flash chip "MX25L6405D" (8192 kB, SPI) on ft2232_spi. Chip status register is 0xff. Chip status register: Status Register Write Disable (SRWD, SRP, ...) is set Chip status register: Bit 6 is set Chip status register: Block Protect 3 (BP3) is set Chip status register: Block Protect 2 (BP2) is set Chip status register: Block Protect 1 (BP1) is set Chip status register: Block Protect 0 (BP0) is set Chip status register: Write Enable Latch (WEL) is set Chip status register: Write In Progress (WIP/BUSY) is set This chip may contain one-time programmable memory. flashrom cannot read and may never be able to write it, hence it may not be able to completely clone the contents of this chip (see man page for details). Some block protection in effect, disabling... Need to disable the register lock first... Error: WIP bit after WRSR never cleared spi_write_status_register failed. Reading old flash chip contents... done. Erasing and writing flash chip... Trying erase function 0... 0x000000-0x000fff:E