[flashrom] Add chip Pm39LV512

[Kyösti Mälkki]

On Sat, 2012-05-19 at 21:50 +0200, Paul Menzel wrote:
> Dear Kyösti,
> 
> 
> Am Samstag, den 19.05.2012, 22:09 +0300 schrieb Kyösti Mälkki:
> > This flash is like PMC model Pm39LV010 but capacity is 64kB.
> 
> could you add a link to the data sheet to the commit message?

Done. I found no official site, though.

> > Model ID was already defined, PREW works for me.
> 
> Could you also sent the output of `flashrom -Vr` and the other commends
> to the list for archival purposes.
> 

I will do so. I used IT8212F PCI PATA card as a programmer, need to
submit that patch too.


> > Signed-off-by: Kyösti Mälkki <kyosti.malkki at gmail.com>
> > 
> > Index: flashrom-pmc64k/flashchips.c
> > ===================================================================
> > --- flashrom-pmc64k/flashchips.c	(revision 1538)
> > +++ flashrom-pmc64k/flashchips.c	(working copy)
> > @@ -5267,6 +5267,36 @@
> >  
> >  	{
> >  		.vendor		= "PMC",
> > +		.name		= "Pm39LV512",
> 
> If this list is sorted, it should go after »Pm39LV010«.
> 

Done. It's after Pm39LV040 now.

> > +		.bustype	= BUS_PARALLEL,
> > +		.manufacture_id	= PMC_ID_NOPREFIX,
> > +		.model_id	= PMC_PM39LV512,
> > +		.total_size	= 64,
> > +		.page_size	= 4096,
> > +		.feature_bits	= FEATURE_ADDR_2AA | FEATURE_EITHER_RESET,
> > +		.tested		= TEST_OK_PREW,
> > +		.probe		= probe_jedec,
> > +		.probe_timing	= TIMING_ZERO,	/* Datasheet has no timing info specified */
> > +		.block_erasers	=
> > +		{
> > +			{
> > +				.eraseblocks = { {4 * 1024, 16} },
> > +				.block_erase = erase_sector_jedec,
> > +			}, {
> > +				.eraseblocks = { {64 * 1024, 1} },
> > +				.block_erase = erase_block_jedec,
> > +			}, {
> > +				.eraseblocks = { {64 * 1024, 1} },
> > +				.block_erase = erase_chip_block_jedec,
> > +			}
> > +		},
> > +		.write		= write_jedec_1,
> > +		.read		= read_memmapped,
> > +		.voltage	= {2700, 3600},
> > +	},
> > +
> > +	{
> > +		.vendor		= "PMC",
> >  		.name		= "Pm39LV010",
> >  		.bustype	= BUS_PARALLEL,
> >  		.manufacture_id	= PMC_ID_NOPREFIX,
> 
> With the above comments addressed, you can add
> 
>     Acked-by: Paul Menzel <paulepanter at users.sourceforge.net>
> 
> to the [PATCH v2].
> 

Done.

> 
> Thanks,
> 
> Paul
> _______________________________________________
> flashrom mailing list
> flashrom at flashrom.org
> http://www.flashrom.org/mailman/listinfo/flashrom