[coreboot] [baytrail_FSP] question about lpss device with ACPI mode in win8
zoran.stojsavljevic at gmail.com
Mon May 16 11:16:33 CEST 2016
Again, I'll repeat my questions:
 Are you talking about BIOS, where you are enabling in LPSS ACPI
(disabling automatically PCI) mode?
 I need better explanation of your use case... Are you using BYT MR4,
then MR5, or instead MR4 BIOS, or...?
 For WIN8.1 you need to have the following:
For BIOS to work (and get rid off these yellow triangles with
[A] ACPI mode in BIOS: South Cluster Configuration -> LPSS & SCC
Configuration -> LPSS LPSS & SCC
Devices Mode -> Select "ACPI Mode";
[B] The GPIO controller driver is/should be prerequisite for HS-UART
driver. There is a document named:
Intel_Processor_Win8_IO_Drivers_Gold_MR1. You should ask for it
from INTEL support. If installed
correctly, you should see HS-UART Controller device under
System Devices in Device Manager. Also
new unknown devices should appear: ACPI\BCM2E1A and
ACPI\BCM4752. These devices are for
HS-UART Sub Device Driver;
[C] You should compile the UART Sub Device Driver (by 1.2.1 of Intel
Atom E3800 Win8.1 HS-UART Sub
Device Driver Sample Code Guide_1.0), and install after
building them. After that you should see Ports in
On Fri, May 13, 2016 at 5:43 AM, cheng yichen <blessyichen at gmail.com> wrote:
> HI all
> I try to enable Lpss device(i2c hs-uart) with ACPI mdoe.
> i2c and hs-uart will show yellow mark in device manager with win8.1.
> but I can't find the same issue in intel coreboot(versrion MR5).
> Do you have any idea for the issue? Thank you
> coreboot mailing list: coreboot at coreboot.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the coreboot