[SeaBIOS] [PATCH] usb: Update USB hub code to support super speed hubs

[Werner Zeh]

Hi Kevin.

I tried your patch and it works just fine for me.
I made a test with a baytrail based board and the earlier mentioned USB-Hub.
Thanks a lot for the really fast replay, great support!

Werner

> Gesendet: Mittwoch, 17. Dezember 2014 um 14:14 Uhr
> Von: "Kevin O'Connor" <kevin at koconnor.net>
> An: "Paul Menzel" <paulepanter at users.sourceforge.net>
> Cc: seabios at seabios.org, "Werner Zeh" <werner.zeh at gmx.net>
> Betreff: Re: [SeaBIOS] [PATCH] usb: Update USB hub code to support super speed hubs
>
> On Tue, Dec 16, 2014 at 11:06:29PM +0100, Paul Menzel wrote:
> > Dear Kevin,
> > 
> > thank you for the patch! I am adding Werner to CC.
> > 
> 
> The patch from this email was identical to the patch I sent the other
> day.
> 
> > Am Montag, den 15.12.2014, 21:47 -0500 schrieb Kevin O'Connor:
> > > Super speed hubs (usb3 spec) have specific initialization
> > > requirements.  Add the code necessary to detect and initialize these
> > > hubs.
> > 
> > Could you please add how you tested this? For example the board, the hub
> > and what you booted from it for example.
> 
> I used an Anker 4 port usb3.0 hub, which I tested with an ADATA 16GB
> usb3.0 flash drive on both my Acer c720 and Asrock e350m1-usb3.
> 
> If you're requesting that info be in the commit message - I don't
> think that level of detail is required there.
> 
> -Kevin
>