[openfirmware] problem with GRUB loaded version

[Dompi]

Hi all,
When trying to build the GRUB loaded flavor of  OpenFirnware ( SVN rev 
1320 ) i
got the following error message during the build process

dompi at OMEGA:~/ofw/cpu/x86/pc/biosload/build$ make
./build ofw.c32
--- Rebuilding reset.di
--- Cmd: ${HOSTDIR}/forth ${HOSTDIR}/../build/builder.dic ../reset.bth
--- Rebuilding start.di
--- Cmd: ${HOSTDIR}/forth ${HOSTDIR}/../build/builder.dic ../start.bth
--- Rebuilding paging.di
--- Cmd: ${HOSTDIR}/forth ${HOSTDIR}/../build/builder.dic ../paging.bth
--- Rebuilding bootsec.hex
--- Cmd: ${HOSTDIR}/forth ${HOSTDIR}/../build/builder.dic ../bootsec.bth
1fe 1f0
400 400
--- Rebuilding fw.img
--- Cmd: ${HOSTDIR}/x86forth ${BP}/cpu/x86/build/basefw.dic ../fw.bth
SAVING FW.dic ...
Saving fw.img ...
--- Rebuilding sd8686.bin
--- Cmd: ${HOSTDIR}/forth ${HOSTDIR}/../build/builder.dic ../sd8686.bth
--- Cmd: rm -f sd8686.bin sd8686_helper.bin
--- Cmd: wget -q 
http://dev.laptop.org/pub/firmware/libertas/sd8686-9.70.7.p0.bin
--- Cmd: wget -q 
http://dev.laptop.org/pub/firmware/libertas/sd8686-9.70.7.p0.bin.md5
--- Cmd: md5sum -b sd8686-9.70.7.p0.bin | cmp - sd8686-9.70.7.p0.bin.md5
--- Cmd: mv sd8686-9.70.7.p0.bin sd8686.bin
--- Cmd: wget -q 
http://dev.laptop.org/pub/firmware/libertas/sd8686_helper.bin
--- Cmd: wget -q 
http://dev.laptop.org/pub/firmware/libertas/sd8686_helper.bin.md5
--- Cmd: md5sum -b sd8686_helper.bin | cmp - sd8686_helper.bin.md5
--- Cmd: rm sd8686-9.70.7.p0.bin.md5 sd8686_helper.bin.md5
--- Rebuilding ofw.c32
--- Cmd: ${HOSTDIR}/forth ${HOSTDIR}/../build/builder.dic ../ofw.bth
--- Saving as ofwgrub.elf - GRUB multiboot format
Can't open ${BP}/dev/mmc/sdhci/build/sdhci.fc for reading.
make: *** [ofw.c32] Erreur 1

After replacing  sdhci.fc wiith sdhci2.fc ( line 105 in ofw.bth  )  the 
build was  successfull.
But that was  not the story end :
    when loaded by GRUB the image crashed badly with a black screen 
followed by a reboot.
Looking at the code i noticed the report mecanism that outputs progress 
messages
on the COM1 port.
With rev 1320 i got the following pattern :
       For
With rev 1163 ( which is OK ) i got the regular Forthmacs banner.
It seems to me that the paging module is not executing at all with a 
crash as a consequence.
I built rev 1166 which introduced lot of changes in resetend.fth and in 
the memory setup
    it also crashes.
I would appreciate any help as i am stuck at the moment.
       Dompi.