[flashrom] ASUS M2N-MX board enable needed?

[nicolae788 .]

Hi hi regarding the board enable problem you might not have permission to
write the boot block. You can check this by checking if there are 3.3 V on
the no.8 pin of the PLCC. If you do not have then you must enable a Gpio to
pull this high ( +3.3 V) . I have the same problem but haven't got the time
to solve it... Any feedback, if you succeed would be appreciated.

Good luck
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.flashrom.org/pipermail/flashrom/attachments/20150310/ccd4cb1d/attachment.html>