[flashrom] Spansion S25FL128P......X

[Stefan Tauner]

On Sun, 16 Nov 2014 11:36:09 +0100
The Raven <originalraven at hotmail.com> wrote:

> I have a spansion S25FL128P......X chip and can do some tests.
> The "problem" is that i don't know if its an 0 or an 1.
> On the chip i see only "FL128PIF" and one line lower i see "00299012 C".
> 
> Probing works (id1 0x01, id2 0x2018):
> Calibrating delay loop... OK.
> serprog: Programmer name is "serprog-duino"
> Found Spansion flash chip "S25FL128P......0" (16384 kB, SPI) on serprog.
> Found Spansion flash chip "S25FL128P......1" (16384 kB, SPI) on serprog.
> Found Spansion flash chip "S25FL128S......0" (16384 kB, SPI) on serprog.
> Found Spansion flash chip "S25FL128S......1" (16384 kB, SPI) on serprog.
> Found Spansion flash chip "S25FL129P......0" (16384 kB, SPI) on serprog.
> Found Spansion flash chip "S25FL129P......1" (16384 kB, SPI) on serprog.
> Multiple flash chip definitions match the detected chip(s):
> "S25FL128P......0", "S25FL128P......1", "S25FL128S......0",
> "S25FL128S......1", "S25FL129P......0", "S25FL129P......1"
> Please specify which chip definition to use with the -c <chipname> option.
> 
> 
> BTW: Chip was fund on a Dell-Systemboard.

Seems to be a S25FL128P......0 according to the "S25FL128P Valid
Combinations Table" in the datasheet. A ...1 would be marked as FL128PIFL.
Testing writes should be able to verify that because it would print
an error message if the wrong one is used (I think).

-- 
Kind regards/Mit freundlichen Grüßen, Stefan Tauner