[flashrom] VIA VT6421A (HZ-006)

[Roy]

在 Sat, 29 Dec 2012 18:14:23 +0800, Stefan Tauner  
<stefan.tauner at student.tuwien.ac.at> 寫道:

> On Fri, 28 Dec 2012 16:52:58 +0800
> Roy <roytam at gmail.com> wrote:
>
>> 2012/12/28 Stefan Tauner <stefan.tauner at student.tuwien.ac.at>:
>> >
>> > I am not entirely sure what happens there. Obviously pcidev_readbar
>> > reads 0... but we are not using that anyway and don't abort in that
>> > case AFAICS. There has been some discussion about refactor these parts
>> > and that would at least get rid of that message. I'll have to
>> > investigate and discuss this with my colleagues.
>> > What happens after that? flashrom exits?
>> > Can you please add -VVV to the command line and resend the resulting
>> > log?
>>
>> Sure.
>>
>> […]
>> Error: No supported PCI device found.
>
> Ah, I missed an obvious exit call... attached hack should get you
> further. If it does not work out of the box you can try the offset
> parameter with different values where the n upper bits are all 1 and
> everything below that is 0, e.g. for n=12 -p atavia:offset=0xfff00000
> Please resend a -VVV log.
>

The patch is not working for me, pcidev_dev in atavia_init() is NULL here.