[flashrom] [PATCH 3/4] Unify usbdev_status and pcidev_status into dev_status.

Carl-Daniel Hailfinger c-d.hailfinger.devel.2006 at gmx.net
Wed Dec 26 21:07:22 CET 2012


Am 25.12.2012 12:31 schrieb Stefan Tauner:
> Once upon a time usbdev_status was created for the ft2232
> programmer. Its IDs are semantically different to pcidev_status
> because they indicate USB instead of PCI IDs, but apart from that
> both data structures are equal. This change makes life easier for
> everything involved in handling and printing the status of devices
> that is noted in those structures by combining them into dev_status.
>
> It is still possible to distinguish between PCI and USB devices
> indirectly by using the struct programmer's type field.
>
> Signed-off-by: Stefan Tauner <stefan.tauner at student.tuwien.ac.at>

Apart from the hunk below (print_supported_pcidevs is dead, kill it and
don't just move it), this is

Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006 at gmx.net>


> diff --git a/programmer.h b/programmer.h
> index e2bb3d8..305bd00 100644
> --- a/programmer.h
> +++ b/programmer.h
> @@ -241,12 +248,6 @@ int rpci_write_word(struct pci_dev *dev, int reg, uint16_t data);
>  int rpci_write_long(struct pci_dev *dev, int reg, uint32_t data);
>  #endif
>  
> -/* print.c */
> -#if CONFIG_NIC3COM+CONFIG_NICREALTEK+CONFIG_NICNATSEMI+CONFIG_GFXNVIDIA+CONFIG_DRKAISER+CONFIG_SATASII+CONFIG_ATAHPT+CONFIG_NICINTEL+CONFIG_NICINTEL_SPI+CONFIG_OGP_SPI+CONFIG_SATAMV >= 1
> -/* Not needed for CONFIG_INTERNAL, but for all other PCI-based programmers. */
> -void print_supported_pcidevs(const struct pcidev_status *devs);
> -#endif
> -
>  struct usbdev_status {
>  	uint16_t vendor_id;
>  	uint16_t device_id;
> @@ -262,6 +263,12 @@ struct pcidev_status {
>  	const char *device_name;
>  };
>  
> +/* print.c */
> +#if CONFIG_NIC3COM+CONFIG_NICREALTEK+CONFIG_NICNATSEMI+CONFIG_GFXNVIDIA+CONFIG_DRKAISER+CONFIG_SATASII+CONFIG_ATAHPT+CONFIG_NICINTEL+CONFIG_NICINTEL_SPI+CONFIG_OGP_SPI+CONFIG_SATAMV >= 1
> +/* Not needed for CONFIG_INTERNAL, but for all other PCI-based programmers. */
> +void print_supported_pcidevs(const struct pcidev_status *devs);
> +#endif
> +
>  #if CONFIG_INTERNAL == 1
>  /* board_enable.c */
>  int board_parse_parameter(const char *boardstring, const char **vendor, const char **model);

Regards,
Carl-Daniel

-- 
http://www.hailfinger.org/





More information about the flashrom mailing list