[flashrom] [PATCH] Remove sharplhf00l04.c

Carl-Daniel Hailfinger c-d.hailfinger.devel.2006 at gmx.net
Tue Jun 21 23:46:14 CEST 2011

Am 20.06.2011 07:42 schrieb Michael Karcher:
> Am Montag, den 20.06.2011, 01:59 +0200 schrieb Carl-Daniel Hailfinger:
>>> The locking blocks of the FWH block lock cover 128KB areas, and thats
>>> the only thing page_size is used for in the functions referenced in the
>>> LHF00L04 entry.
>> My datasheet talks about 8 kB sectors and 64 kB blocks in "Figure 3.
>> Memory Map", but "Table 8. FWH Flash Registers Configuration Map" only
>> mentions registers for the 8 kB sectors in the top 64 kB block
>> explicitly. "Table 8" also mentions "XX002H Whole Block Lock Register"
>> as generic placeholder, and AFAICS those two X mean you have one block
>> lock register for each of the 15 bottom 64 kB blocks and one for each of
>> the 8 top 8 kB sectors. That also means the 82802ab unlocking as is
>> can't be used.
> I'm looking at Sharp Spec No. FM037006, Issue Date: June 18, 2003

Same here.

> You are right that the erase block size is 64kB as shown e.g. in figure
> 3. This is not touched by my patch, though. Taking a close look at table
> 8, I read it as: The whole block locking bit (affecting the whole flash
> chip area 0-1M) is possibly accessible each 4KB, but no matter what
> address you use, you get to the same single "master write protect" bit.
> This bit is located at data bit 1. On the other hand, the bits locking
> only parts of the flash chip are mentioned in the lines below that, with
> a "Protected address range of 128KB

My datasheet (same date, same number) does not mention 128 kB ranges at all.

>  each and addresses of F0002h,
> F2002h, F4002h, F6002h, F8002h, FA002h, FC002h and FE002h.

Those addresses are, respectively:

hex   decimal        offset
f0002 15*64k+0*4k+2  0k
f2002 15*64k+2*4k+2  8k
f4002 15*64k+4*4k+2  16k
f6002 15*64k+6*4k+2  24k
f8002 15*64k+8*4k+2  32k
fa002 15*64k+10*4k+2 40k
fc002 15*64k+12*4k+2 48k
fe002 15*64k+14*4k+2 56k

At a first glance, it is easy to assume an additional hex digit in the
middle because we're so used to it. That may the reason you were seeing
128 kB blocks which I can't find here.

>  These 8
> "sector-specific" lock bits are located at bit 0. Nowhere this table
> mentions anything about bits affecting only 8KB sized areas.
> On the other hand, text of the data sheet nowhere mentions the
> sectorwise locking - it is just in the table. I have no idea how to read
> that.



More information about the flashrom mailing list