[flashrom] MCP65 on MSI MS-7369 (2007)

[Kjell Braden]

On 04.07.2010 14:56, Melchior FRANZ wrote:
> Here's my report for:
> 
>   NVIDIA MCP65 
>   MSI MS-7369  "K9N Neo V2"  v1.0  (2007)
> 
> After the -V run the machine still booted and behaves normally.  :-)
> Here the relevant lines from the output:
> 
>   Found chipset "NVIDIA MCP65", enabling flash write... chipset PCI ID is 10de:0441
>   ISA/LPC bridge reg 0x8a contents: 0x40, bit 6 is 1, bit 5 is 0
>   Guessed flash bus type is SPI
>   Found SMBus device 10de:0446 at 00:01:1
>   SPI BAR is at 0xfec80000, after clearing low bits BAR is at 0xfec80000
>   SPI control is 0x0002, enable=0, idle=0
> 
>   Probing for Winbond W25x80, 1024 KB: probe_spi_rdid_generic: id1 0xef, id2 0x3014
>   Chip status register is 00 
>   Found chip "Winbond W25x80" (1024 KB, SPI) at physical address 0xfff00000.
> 
> m.


Not sure if that's relevant, but I seem have the same board and my
results differ:

---
Probing for Macronix MX25L8005, 1024 KB: probe_spi_rdid_generic: id1
0xc2, id2 0x2014
Chip status register is 00
Chip status register: Status Register Write Disable (SRWD) is not set
Chip status register: Bit 6 is not set
Chip status register: Bit 5 / Block Protect 3 (BP3) is not set
Chip status register: Bit 4 / Block Protect 2 (BP2) is not set
Chip status register: Bit 3 / Block Protect 1 (BP1) is not set
Chip status register: Bit 2 / Block Protect 0 (BP0) is not set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
Found chip "Macronix MX25L8005" (1024 KB, SPI) at physical address
0xfff00000.
---

See my other reply from July 3 for the full output.

HTH
-Kjell