[flashrom] Board enable for EPoX EP-8RDA3+

[Carl-Daniel Hailfinger]

Hi Anol,

On 16.09.2009 00:29, . . wrote:
> Problem is chip not being able to be flashed, looks write-protected.
> No write-enable jumpers or options in BIOS setup.
> Here are the requested info's:
> Motherboard: EPoX EP-8RDA3+ (Rev 2.1)
> BIOS download location: http://www.epox.ru/downloads.php?file=/data/download/bios/8rd34729.bin
>
> lspci -nnvvvxxx output:
> ---start---
> 00:00.0 Host bridge [0600]: nVidia Corporation nForce2 AGP (different version?) [10de:01e0] (rev c1)
> [...]
> 00:09.0 IDE interface [0101]: nVidia Corporation nForce2 IDE [10de:0065] (rev a2) (prog-if 8a [Master SecP PriP])
> [...]
> 01:06.0 RAID bus controller [0104]: Silicon Image, Inc. SiI 3114 [SATALink/SATARaid] Serial ATA Controller [1095:3114] (rev 02)
> [...]
> ---end---
>   

Very strange. It seems that the majority of PCI devices on your board is
missing is the lspci output above. Are you sure you pasted the full
lspci output?


> flashrom -V output:
> ---start---
> flashrom v0.9.1-r719
> No coreboot table found.
> Found chipset "NVIDIA NForce2", enabling flash write... OK.
> This chipset supports the following protocols: Non-SPI.
> Calibrating delay loop... 614M loops per second, 100 myus = 201 us. OK.
> [...]
> Probing for Winbond W39V040A, 512 KB: probe_jedec: id1 0xda, id2 0x3d
> Found chip "Winbond W39V040A" (512 KB, LPC) at physical address 0xfff80000.
> No operations were specified.
>   


Regards,
Carl-Daniel

-- 
http://www.hailfinger.org/