[flashrom] [PATCH] Verbose probe output improvements

[Carl-Daniel Hailfinger]

Verbose probe output is split across multiple lines for some probe
functions. This makes visual inspection and grepping a lot harder than
necessary.
Remove line breaks where appropriate.

Output of "flashrom -V" on various chipsets and programmers is appreciated.

Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006 at gmx.net>

Index: flashrom-verbose_probe_oneline/jedec.c
===================================================================
--- flashrom-verbose_probe_oneline/jedec.c	(Revision 655)
+++ flashrom-verbose_probe_oneline/jedec.c	(Arbeitskopie)
@@ -99,7 +99,7 @@
 		probe_timing_enter = probe_timing_exit = 0;
 	} else if (flash->probe_timing == TIMING_FIXME) { /* == _IGNORED */
 		printf_debug("Chip lacks correct probe timing information, "
-			     "using default 10mS/40uS\n");
+			     "using default 10mS/40uS. ");
 		probe_timing_enter = 10000;
 		probe_timing_exit = 40;
 	} else {
Index: flashrom-verbose_probe_oneline/spi.c
===================================================================
--- flashrom-verbose_probe_oneline/spi.c	(Revision 655)
+++ flashrom-verbose_probe_oneline/spi.c	(Arbeitskopie)
@@ -99,7 +99,7 @@
 	printf_debug("RDID returned");
 	for (i = 0; i < bytes; i++)
 		printf_debug(" 0x%02x", readarr[i]);
-	printf_debug("\n");
+	printf_debug(". ");
 	return 0;
 }
 
@@ -177,12 +177,12 @@
 		return 0;
 
 	if (!oddparity(readarr[0]))
-		printf_debug("RDID byte 0 parity violation.\n");
+		printf_debug("RDID byte 0 parity violation. ");
 
 	/* Check if this is a continuation vendor ID */
 	if (readarr[0] == 0x7f) {
 		if (!oddparity(readarr[1]))
-			printf_debug("RDID byte 1 parity violation.\n");
+			printf_debug("RDID byte 1 parity violation. ");
 		id1 = (readarr[0] << 8) | readarr[1];
 		id2 = readarr[2];
 		if (bytes > 3) {


-- 
http://www.hailfinger.org/