[coreboot] Install Coreboot into KGPE-D16 (Cloud Dai)

[Elisenda Cuadros]

Hello,

I'm using and old Thermaltake 430W PSU, single CPU + dedicated graphics 
card.

No problems at the moment.

Regards,

- Eli


On 11/03/18 20:25, Taiidan at gmx.com wrote:
> On 03/11/2018 08:06 AM, Jason Lenz wrote:
>
>> I viewed your blog post and it sounds like you are using the stock 
>> bios to confirm the board works properly before flashing coreboot.  I 
>> believe the problem is that your power supply itself does not have 
>> enough capacity.  I have experienced the problem myself when I first 
>> tested my KGPE board.  The motherboard draws a lot of current 
>> initially at start up and my first power supply had an internal 
>> protection circuit that would activate and stop it due to overload 
>> drawing too much current.  Once I upgraded to a higher capacity power 
>> supply everything worked fine.  I bought a 1000w power supply which 
>> was probably more than needed, but with this power supply the 
>> motherboard started up fine.  Can you borrow a larger capacity power 
>> supply from a friend to test it?  Best of luck to you.  I also had no 
>> problem understanding your English.
> Ah thank you I did not read the blog post myself.
>
> Yeah you need a quality PSU with one EPS12V connection per CPU, I am 
> able to run my single CPU system with a 550W PSU but it is very high 
> quality - cheap PSU's are usually over-rated.
>