[coreboot] coreboot solidpc
Piotr Król
piotr.krol at 3mdeb.com
Wed Dec 14 14:35:16 CET 2016
On Wed, Dec 14, 2016 at 02:05:12PM +0000, Peter Stuge wrote:
> sebastien basset wrote:
Hi Peter,
> > For flashing board solidpc,
> > 1/ plug power supply (without pressing the power button)
> > 2/ connect dediprog on j8 connector( with good cable)
> > 3/ ./flashrom -p dediprog:voltage=1.8V -w solidrun.rom
>
> Why 1.8V? Is there a schematic available for this board?
Please take a look at this:
http://www.solid-run.com/wiki/doku.php?id=products:ibx:software:development:bios
Information on page say:
Notice that the programmer must drive 1.8v signals; otherwise the main
processor might get damaged
Best Regards,
--
Piotr Król
Embedded Systems Consultant
http://3mdeb.com | @3mdeb_com
More information about the coreboot
mailing list