[coreboot] coreboot solidpc

[sebastien basset]

in http://wiki.solid-run.com/doku.php?id=products:ibx:documents ,
there is SolidPC
Schematics :

page 1 : you can read:

*""Notice that the programmer must drive 1.8v signals; otherwise*
*the main processor might get damaged.""*


2016-12-14 15:05 GMT+01:00 Peter Stuge <peter at stuge.se>:

> sebastien basset wrote:
> > For flashing board solidpc,
> > 1/  plug power supply (without pressing the power button)
> > 2/ connect dediprog on j8 connector( with good cable)
> > 3/ ./flashrom -p dediprog:voltage=1.8V -w solidrun.rom
>
> Why 1.8V? Is there a schematic available for this board?
>
>
> //Peter
>
> --
> coreboot mailing list: coreboot at coreboot.org
> https://www.coreboot.org/mailman/listinfo/coreboot
>



-- 
Sébastien Basset
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.coreboot.org/pipermail/coreboot/attachments/20161214/388185ce/attachment.html>