[coreboot] "No valid softstrap base found." hang?

[Alp Eren Köse]

Sorry I didn't get you? But there is something wrong here, if I print the
sysinfo->ranks it shows 255, and the other sysinfo as following:
------------ Serial output ------------
US15W Chipset
Unknown (07)Setting up ACPI PM1 block Setting up ACPI P block  done.
Setting up RAM controller.
READ BASE_ADDR=fffc0000
sysinfo-ranks=255
sysinfo-cl=3
sysinfo-trcd=3
sysinfo-trp=3
sysinfo-device_density=3
sysinfo-data_width=1
sysinfo-refresh=3
PASSED DETECT_SOFTSTRAPS.
Setting up RAM
Setting up RAM
Setting up RAM
-- 255 times prints "Setting up RAM" line..

Then I suppose it hangs in the "sch_shadow_CMC(void)" function trying to
memcpy something CMC_SHADOW??
But I think the problem is earlier..
Any ideas what I can do here?

Thanks in advance,
Alp

2011/10/26 Kyösti Mälkki <kyosti.malkki at gmail.com>

> On Wed, 2011-10-26 at 16:42 +0300, Alp Eren Köse wrote:
>
> > Ok I get passed the "Setting up RAM controller." now, but stuck now in
> > "Setting up RAM" as can be seen above I print the detected softstrap
> > base, and it says fffc0000.
>
>
> Wild guess, but where did I put that CMC binary again?
>
> KM
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.coreboot.org/pipermail/coreboot/attachments/20111026/5dea0cfc/attachment.html>