[coreboot] Getting serial output from w83627hf?
vidwer at gmail.com
Mon Oct 17 17:08:00 CEST 2011
2011/10/17 Alp Eren Köse <alperenkose at buyutech.com.tr>
> Hi all,
> I can't get serial output from the board I am trying to put coreboot on, so
> I am not able to go any further to see whats going on..
> The board has a Winbond W83627HF/F/HG/G (id=0x52, rev=0x41) at 0x2e.
It is likely that you need to set the serial port's speed in romstage.c:
// omitting includes, license header
#define SERIAL_DEV PNP_DEV(0x2e, W83627HF_SP1)
Add this line to main():
> I couldn't figure out where to put the "chip superio/winbond/w83627hf"
> section in the "devicetree.cb" file layout?
SCH boards don't use the serial port but the EHCI debug port to show output
on? See src/mainboard/iwave/iWRainbowG6/devicetree.cb, it doesn't have the
What I would do is put it inside the LPC bridge section, note that I don't
know how the superio is actually attached and therefore could be wrong.
device pci 1f.0 on # lpc bridge
end # superio
end # 1f.0
> Could someone please explain the devicetree.cb file structure? or point a
> The "lspci -tvnn" output and my modified "devicetree.cb" file are at the
> Thanks in advance,
> coreboot mailing list: coreboot at coreboot.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the coreboot