[coreboot] Seabios - VGA & Boot From First Hard Drive Issues

[Roger]

VGA is on PCI 01:00


01:00.0 VGA compatible controller: nVidia Corporation NV25 [GeForce4 Ti 4200] (rev a3) (prog-if 00 [VGA controller])
        Subsystem: Micro-Star International Co., Ltd. Device 8700
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 32 (1250ns min, 250ns max)
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at e4000000 (32-bit, non-prefetchable) [size=16M]
        Region 1: Memory at d0000000 (32-bit, prefetchable) [size=128M]
        Region 2: Memory at d8000000 (32-bit, prefetchable) [size=512K]
        [virtual] Expansion ROM at d8080000 [disabled] [size=128K]
        Capabilities: [60] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [44] AGP version 2.0
                Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW+ AGP3- Rate=x1,x2,x4
                Command: RQ=32 ArqSz=0 Cal=0 SBA+ AGP+ GART64- 64bit- FW- Rate=x2
        Kernel driver in use: nouveau
        Kernel modules: nouveau

-- 
Roger
http://rogerx.freeshell.org/