[coreboot] SeaBIOS WinXP install

[Myles Watson]

> Here is the lspci for both legacy and coreboot :
> -----------------------------------------------
> legacy :
> 00:1f.2 IDE interface: Intel Corporation EP80579 S-ATA IDE (rev 01)
> (prog-if 8f [Master SecP SecO PriP PriO])
>     Subsystem: Intel Corporation EP80579 S-ATA IDE
>     Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 58
>     I/O ports at f080 [size=8]
>     I/O ports at f070 [size=4]
>     I/O ports at f060 [size=8]
>     I/O ports at f050 [size=4]
>     I/O ports at f040 [size=16]
>     Memory at d0100000 (32-bit, non-prefetchable) [size=1K]
>     Capabilities: [70] Power Management version 2
> 
> 00:1f.2 IDE interface: Intel Corporation EP80579 S-ATA IDE (rev 01)
> (prog-if 8f [Master SecP SecO PriP PriO])
>     Subsystem: Intel Corporation Unknown device 2680
>     Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 145
>     I/O ports at 2410 [size=8]
>     I/O ports at 2420 [size=4]
>     I/O ports at 2418 [size=8]
>     I/O ports at 2424 [size=4]
>     I/O ports at 2400 [size=16]
>     Memory at d4a07400 (32-bit, non-prefetchable) [size=1K]
>     Capabilities: [70] Power Management version 2
> 
> Actually same except io ports are located another place and the
> subsystem IDs is set differently by the driver. I do
> not think the last one would cause any troubles.
I don't think the IO port location is a problem, unless it conflicts with
something in the DSDT.  The IRQ setting is also different. 145 seems pretty
high.

Thanks,
Myles