[coreboot] [PATCH] CN400 / EPIA-NL [v2] patch

[Harrison, Jon (SELEX GALILEO, UK)]

Hi Peter,

I'll rework the patch a bit then.

Thanks for the spot on the second part, I thought I'd taken that out
already.

Ta,
Jon

------------------------------

Message: 4
Date: Tue, 7 Jul 2009 18:30:55 +0200
From: Peter Stuge <peter at stuge.se>
To: coreboot at coreboot.org
Subject: Re: [coreboot] [PATCH] CN400 / EPIA-NL [v2] patch
Message-ID: <20090707163055.13999.qmail at stuge.se>
Content-Type: text/plain; charset=us-ascii

Hey Jon,

Harrison, Jon (SELEX GALILEO, UK) wrote:
> Attached is v5 of the CN400/EPIA-NL patch for Coreboot V2.
> 
> This has been built and tested against R4404.
> 
> The status as follows:
> 1/ Board sucessfully boots and launches FILO 0.6.0 payload.
> 2/ VGA framebuffer seems to work OK. (with factory VGA BIOS and BOCHS
> helpers)

Nice progress! Other than my few concerns, I think this is a good
patch.


Content-Description: cn400-patch-v5.patch
> Index: src/mainboard/via/epia-n/Config.lb
..
> -chip northbridge/via/cn400			# Northbridge
..
> +chip northbridge/via/cn400				# Northbridge

It seems that there are quite a few whitespace only changes in this
patch. It would be very helpful if you could split up the patch into
several parts; one for functional changes and one for whitespace
corrections.


> Index: src/northbridge/via/cn400/northbridge.c
..
> @@ -193,27 +202,29 @@
>  
>  		/*
>  		 * Once the register value is not zero, the RAM size is
> -		 * this register's value multiply 64 * 1024 * 1024.
> -		 */
> +		 * this register's value multiply 32 * 1024 * 1024.
> +		 *
>  		for (rambits = 0, i = 0; i < ARRAY_SIZE(ramregs); i++) {
>  			rambits = pci_read_config8(mc_dev, ramregs[i]);
>  			if (rambits != 0)
>  				break;
>  		}
> -
> -		tomk = rambits * 64 * 1024;
> -		printk_spew("tomk is 0x%x\n", tomk);
> +		*/
> +		rambits = pci_read_config8(mc_dev, 0x47);
> +		tomk = rambits * 32 * 1024;

This hunk is really too tricky. Please remove the lines if they
should not be in there.


Thanks!

//Peter
SELEX Sensors and Airborne Systems Limited
Registered Office: Sigma House, Christopher Martin Road, Basildon, Essex SS14 3EL
A company registered in England & Wales.  Company no. 02426132
********************************************************************
This email and any attachments are confidential to the intended
recipient and may also be privileged. If you are not the intended
recipient please delete it from your system and notify the sender.
You should not copy it or use it for any purpose nor disclose or
distribute its contents to any other person.
********************************************************************