[coreboot] alix1c PATA

[Peter Stuge]

On Fri, May 02, 2008 at 09:49:03PM -0700, ron minnich wrote:
> >  Is there a special trick? Does v3 disable PATA?
> >  (It is enabled by default from reset.)
> 
> I'm afraid you are in new territory. I have only booted the CF.

I'm trying to boot CF too. FILO loads the kernel fine.


> Oh wait it shouldn't matter -- you moved the jumper right?
> Isn't it all jumper based?

Jumper still on "ON=CF master"


> can you try with a cf root just to see if that works at all?

========== mainboard_pre_payload: done =========================================
FILO version 0.5 (stuge at n410c) Thu Jan 24 04:17:59 CET 2008
boot: hda1:/vmlinuz root=/dev/hda1 console=tty0 console=ttyS0,115200
hda: LBA 1025MB: SanDisk SDCFX3-1024                     
Mounted ext2fs
Found Linux version 2.6.25 (stuge at n410c) #1 PREEMPT Sat May 3 06:26:40 CEST 2008 bzImage.
Loading kernel... ok
Jumping to entry point...
Linux version 2.6.25 (stuge at n410c) (gcc version 4.2.2 (Gentoo 4.2.2 p1.0)) #1 PREEMPT Sat May 3 06:26:40 CEST 2008
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000b70 - 00000000000a0000 (usable)
 BIOS-e820: 0000000000100000 - 000000000f7e0000 (usable)
247MB LOWMEM available.
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Zone PFN ranges:
  DMA             0 ->     4096
  Normal       4096 ->    63456
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0:        0 ->    63456
DMI not present or invalid.
Allocating PCI resources starting at 10000000 (gap: 0f7e0000:f0820000)
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 62961
Kernel command line: root=/dev/hda1 console=tty0 console=ttyS0,115200
No local APIC present or hardware disabled
Initializing CPU#0
PID hash table entries: 1024 (order: 10, 4096 bytes)
Detected 498.059 MHz processor.
Console: colour dummy device 80x25
console [tty0] enabled
console [ttyS0] enabled
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 247868k/253824k available (2140k kernel code, 5460k reserved, 779k data, 160k init, 0k highmem)
virtual kernel memory layout:
    fixmap  : 0xfffba000 - 0xfffff000   ( 276 kB)
    vmalloc : 0xd0000000 - 0xfffb8000   ( 767 MB)
    lowmem  : 0xc0000000 - 0xcf7e0000   ( 247 MB)
      .init : 0xc03dc000 - 0xc0404000   ( 160 kB)
      .data : 0xc0317170 - 0xc03d9fb8   ( 779 kB)
      .text : 0xc0100000 - 0xc0317170   (2140 kB)
Checking if this processor honours the WP bit even in supervisor mode...Ok.
SLUB: Genslabs=12, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1
Calibrating delay using timer specific routine.. 997.14 BogoMIPS (lpj=498573)
Mount-cache hash table entries: 512
CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 128K (32 bytes/line)
Compat vDSO mapped to ffffe000.
CPU: AMD Geode(TM) Integrated Processor by AMD PCS stepping 02
Checking 'hlt' instruction... OK.
Freeing SMP alternatives: 0k freed
net_namespace: 152 bytes
NET: Registered protocol family 16
PCI: Using configuration type 1
Setting up standard PCI resources
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Probing PCI hardware
PCI: Using IRQ router default [1022/2090] at 0000:00:0f.0
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
NTFS driver 2.1.29 [Flags: R/O].
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
PCI: Guessed IRQ 11 for device 0000:00:01.1
PCI: Sharing IRQ 11 with 0000:00:01.2
lxfb 0000:00:01.1: 8192 KB of video memory at 0xfd000000
fbcon: Geode LX (fb0) is primary device
Console: switching to colour frame buffer device 80x30
fb0: Geode LX frame buffer device
Generic RTC Driver v1.07
AMD Geode RNG detected
Linux agpgart interface v0.103
[drm] Initialized drm 1.1.0 20060810
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP]
parport0: irq 7 detected
loop: module loaded
via-rhine.c:v1.10-LK1.4.3 2007-03-06 Written by Donald Becker
PCI: Guessed IRQ 10 for device 0000:00:0d.0
PCI: Sharing IRQ 10 with 0000:00:0f.3
eth0: VIA Rhine III (Management Adapter) at 0xfe019000, 00:0d:b9:0d:0a:e4, IRQ 10.
eth0: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk at qualcomm.com>
usbcore: registered new interface driver cdc_ether
usbcore: registered new interface driver MOSCHIP usb-ethernet driver
Driver 'sd' needs updating - please use bus_type methods
Driver 'sr' needs updating - please use bus_type methods
pata_cs5536: disabled by BIOS
usbmon: debugfs is not available
PCI: Guessed IRQ 9 for device 0000:00:0f.5
PCI: Sharing IRQ 9 with 0000:00:0f.4
ehci_hcd 0000:00:0f.5: EHCI Host Controller
ehci_hcd 0000:00:0f.5: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0f.5: irq 9, io mem 0xfe017000
ehci_hcd 0000:00:0f.5: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 4 ports detected
PCI: Guessed IRQ 9 for device 0000:00:0f.4
PCI: Sharing IRQ 9 with 0000:00:0f.5
ohci_hcd 0000:00:0f.4: OHCI Host Controller
ohci_hcd 0000:00:0f.4: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:0f.4: irq 9, io mem 0xfe016000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 4 ports detected
usbcore: registered new interface driver usblp
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
drivers/usb/serial/pl2303.c: Prolific PL2303 USB to serial adaptor driver
i8042.c: Can't read CTR while initializing i8042.
i8042: probe of i8042 failed with error -5
mice: PS/2 mouse device common for all mice
WDT driver for the Winbond(TM) W83627HF/THF/HG Super I/O chip initialising.
w83627hf/thf/hg WDT: initialized. timeout=60 sec (nowayout=0)
Bluetooth: HCI USB driver ver 2.9
usbcore: registered new interface driver hci_usb
PCI: Guessed IRQ 11 for device 0000:00:01.2
PCI: Sharing IRQ 11 with 0000:00:01.1
geode-aes: GEODE AES engine enabled.
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.16rc2 (Thu Jan 31 16:40:16 2008 UTC).
PCI: Guessed IRQ 10 for device 0000:00:0f.3
PCI: Sharing IRQ 10 with 0000:00:0d.0
usbcore: registered new interface driver snd-usb-audio
ALSA device list:
  #0: CS5535 Audio cs5535audio at 0x1880, irq 10
NET: Registered protocol family 1
NET: Registered protocol family 17
Bluetooth: L2CAP ver 2.9
Bluetooth: L2CAP socket layer initialized
Bluetooth: SCO (Voice Link) ver 0.5
Bluetooth: SCO socket layer initialized
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
802.1Q VLAN Support v1.8 Ben Greear <greearb at candelatech.com>
All bugs added by David S. Miller <davem at redhat.com>
Using IPI Shortcut mode
VFS: Cannot open root device "hda1" or unknown-block(0,0)
Please append a correct "root=" boot option; here are the available partitions:
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)

No mention of the PATA. Linux doesn't see the CF. :\


//Peter