[coreboot] Asus M2A-VM

[Bao, Zheng]

....
Adjust rom_table_end from 0x000f34d0 to 0x00100000
uma_memory_start=0x78000000, uma_memory_size=0x8000000 Wrote coreboot
table at: 00000530 - 00000778  checksum 5730 ..

Based on your bootlog, coreboot correctly detects your memory
size(uma_memory_start+ uma_memory_size). When does it report 2G memory?

Zheng

-----Original Message-----
From: coreboot-bounces at coreboot.org
[mailto:coreboot-bounces at coreboot.org] On Behalf Of Carl-Daniel
Hailfinger
Sent: Wednesday, December 17, 2008 12:14 PM
To: Coreboot
Subject: Re: [coreboot] Asus M2A-VM

On 17.12.2008 04:39, Carl-Daniel Hailfinger wrote:
> Hi all,
>
> my Asus M2A-VM (690G/SB600) is working and boots to memtest and FILO.
>
> Memtest works fine over serial (well, I only ran memtest until it
> reached 15%).
> FILO can load the kernel, but I didn't have time to enable serial
output
> for my kernel.
>
> Thanks to Zheng Bao for adding support for my 690G graphics.
>
> I'll post a patch soon. Right now, there are a few more bugs to fix.
The
> ncHT fixup is already known, a clean patch will come tomorrow.
>
> On a first boot, I get an endless loop of
>
> drive detection fail,trying...
>
> until I press the reset button. After that, it boots fine. That
message
> is in the SB600 code. I will enable some debugging that was disabled
in
> revision 3785.
>
> Another curiosity is that my power button has become ineffective. It
> simply initiates a reboot instead of switching off the machine after 4
> seconds. That happens only with the FILO payload.
>   

Oh, and it does not find more than 2 GB of RAM. I'll try to debug that
as well.

Right now, I'm happy that it gets to FILO and can load a kernel.

The interrupts are probably wrong. I need to check that.

Regards,
Carl-Daniel

-- 
http://www.hailfinger.org/


--
coreboot mailing list: coreboot at coreboot.org
http://www.coreboot.org/mailman/listinfo/coreboot