[LinuxBIOS] GA M57SLI _really_ supported?

[Carl-Daniel Hailfinger]

On 27.10.2007 03:27, Carl-Daniel Hailfinger wrote:
>> Oh, and here is a nice dmesg diff snippet:
>>
>> --- dmesg.vendor    2007-10-27 03:11:10.000000000 +0200
>> +++ dmesg.LB    2007-10-27 03:11:10.000000000 +0200
>>     
> +  PREFETCH window: disabled.
> +PCI: Bridge: 0000:00:0a.0
> +  IO window: disabled.
> +  MEM window: disabled.
> +  PREFETCH window: disabled.
> +PCI: Bridge: 0000:00:0b.0
> +  IO window: disabled.
> +  MEM window: disabled.
> +  PREFETCH window: disabled.
> +PCI: Bridge: 0000:00:0c.0
> +  IO window: disabled.
> +  MEM window: disabled.
> +  PREFETCH window: disabled.
> +PCI: Bridge: 0000:00:0d.0
> +  IO window: disabled.
> +  MEM window: disabled.
> +  PREFETCH window: disabled.
> +PCI: Bridge: 0000:00:0e.0
> +  IO window: disabled.
> +  MEM window: disabled.
>    PREFETCH window: disabled.
>
> Notice all these added PCI bridges. Fix.
>   

Try this diff (whitespace-damaged):

Index: src/mainboard/gigabyte/m57sli/Config.lb
===================================================================
--- src/mainboard/gigabyte/m57sli/Config.lb     (Revision 2899)
+++ src/mainboard/gigabyte/m57sli/Config.lb     (Arbeitskopie)
@@ -305,6 +305,7 @@
                                                         device i2c 57 on end
                                                 end 
                                        end # SM
+#wtf?!? we already have device pci 1.1 in the section above
                                         device pci 1.1 on # SM 1
 #PCI device smbus address will depend on addon pci device, do we need to scan_smbus_bus?
 #                                                chip drivers/generic/generic #PCIXA Slot1
@@ -340,11 +341,12 @@
                                        device pci 6.1 on end # AZA
                                        device pci 8.0 on end # NIC
                                        device pci 9.0 off end # NIC
-                                       device pci a.0 on end # PCI E 5
-                                       device pci b.0 on end # PCI E 4
-                                       device pci c.0 on end # PCI E 3
-                                       device pci d.0 on end # PCI E 2
-                                       device pci e.0 on end # PCI E 1
+#hope not mentioning these should be sufficient
+#                                      device pci a.0 on end # PCI E 5
+#                                      device pci b.0 on end # PCI E 4
+#                                      device pci c.0 on end # PCI E 3
+#                                      device pci d.0 on end # PCI E 2
+#                                      device pci e.0 on end # PCI E 1
                                        device pci f.0 on end # PCI E 0
                                        register "ide0_enable" = "1"
                                        register "sata0_enable" = "1"




Someone should read the Config.lb thoroughly and check its internal
consistency and validity.

Carl-Daniel