[LinuxBIOS] question about filo fail

[AlexHuang]

Hi all, 

   I used FILO to build a filo.elf, and see the message "Mounted ext2fs".
But it fails on next step, the error message is "File not found

". I am sure that my hard drive has file "/boot/ vmlinuz-2.6.9-1.667". 

The whole messages are as below. 

 

Thanks 

Alex

        

file_open: dev=hda1, path=/boot/vmlinuz-2.6.9-1.667

find_ide_controller: found PCI IDE controller 1039:5513 prog_if=0x80

find_ide_controller: primary channel: compatibility mode

find_ide_controller: cmd_base=0x1f0 ctrl_base=0x3f4

ide_software_reset: Waiting for ide0 to become ready for reset... ok

init_drive: Testing for hda

init_drive: Probing for hda

init_drive: LBA mode, sectors=26520480

init_drive: Init device params... ok

hda: LBA 13GB: IBM-DJNA-371350

init_drive: Testing for hdb

init_drive: Probing for hdb

print_status: IDE: status=0x0, err=0x0

init_drive: Testing for hdb

init_drive: Probing for hdb

print_status: IDE: status=0x0, err=0x0

devopen: Partition 1 start 63 length 208782

Mounted ext2fs

File not found

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.coreboot.org/pipermail/coreboot/attachments/20070515/2a2d8cb0/attachment.html>