[LinuxBIOS] RES: RES: Rumba target and AMD RDK THINCLIENT

[jardel]

Dear Ollie,


   It works !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
   See below the output that i get at serial port of super i/o:
   Please, do same comment about the output. Is the erro pointed below
according to the development stage of project or not ?
  
  
   LinuxBIOS-1.1.8.0Fallback Sex Mar  3 09:23:01 BRT 2006 starting...
CGLP_SYS_RSTPLL 00000010:02008470
prgramming PLL
Reset PLL


LinuxBIOS-1.1.8.0Fallback Sex Mar  3 09:23:01 BRT 2006 starting...
CGLP_SYS_RSTPLL 00000019:07de0378
reboot from BIOS reset
Ram1.00
Ram2.00
Ram3
sdram_enable step 1
sdram_enable step 2
sdram_enable step 3
sdram_enable step 4
sdram_enable step 5
sdram_enable step 6
sdram_enable step 7
sdram_enable step 8
Ram4
Testing DRAM : 00000000-000a0000
DRAM fill: 00000000-000a0000
00000000 00010000 00020000 00030000 00040000 00050000 00060000 00070000
00080000 00090000 000a0000
DRAM filled
DRAM verify: 00000000-000a0000
00000000 00010000 00020000 00030000 00040000 00050000 00060000 00070000
00080000 00090000 000a0000
DRAM verified
Done.
Copying LinuxBIOS to ram.
Jumping to LinuxBIOS.
LinuxBIOS-1.1.8.0Fallback Sex Mar  3 09:23:01 BRT 2006 booting...
clocks_per_usec: 643
Enumerating buses...
Finding PCI configuration type.
PCI: Sanity check failed
pci_check_direct failed



Thanks.


Jardel.



Li-Ta Lo wrote:

>>>>Dear Mr. Li-Ta Lo,
>>>>
>>>>
>>>>    I've tried, but id didn't see any bytes on serial port 0 of the
>>>>CS5535.
>>>>    What is the hardware description of rumba target ?  I'm trying it
>>>>on the AMD RDK THINCLIENT based on GEODE GX2.
>>>>
>>>>
>>>>        
>>>>
>>>I think our board is the thinclient RDK with the winbond superio duaght
>>>board. Did you get the lastest code? Does it compile?
>>>
>>>
>>>      
>>>
>>My Daught board (LPC Expansion) uses the NSC PC87364, the wich is the
>>same WINBOND 87364. I compile successfull the last code, but i was not
>>able to see anything on serial port 0 of CS5535. But something is clear
>>for me now: if you don't have VSA initialized, you aren't able for using
>>serial port of companion chip.  As a matter of fact, you are probably
>>sending the bytes to port 0 of winbond super i/o, isn' t ?
>>Are you really sending the debug output for port 0 of  WINBOND 87364 ?
>>
>>    
>>
>
>Yes, I am sending to the serial port on the superio chip, not the
>internal UART of GX/CS5535.
>
>Ollie
>
>
>  
>