Freebios2 recovery progress... moving enable_childrens_resour ces
YhLu
YhLu at tyan.com
Thu Oct 21 16:12:00 CEST 2004
Eric,
Why moving
enable_childrens_resources(dev);
from void pci_dev_enable_resources(struct device *dev)
to
void pci_bus_enable_resources(struct device *dev)
the superio under the PCI device will not be enabled with resources.
Regards
YH
-----Original Message-----
From: YhLu
Sent: Thursday, October 21, 2004 2:03 PM
To: ebiederman at lnxi.com
Cc: LinuxBIOS
Subject: RE: Freebios2 recovery progress...
It's OK.
PCI: 04:01.0 bridge ctrl <- 0003
PCI: 04:01.0 cmd <- 146
PCI: 05:04.0 cmd <- 142
PCI: 04:01.1 subsystem <- 10f1/2895
PCI: 04:01.1 cmd <- 146
PCI: 04:02.0 bridge ctrl <- 0003
PCI: 04:02.0 cmd <- 147
PCI: 06:06.0 cmd <- 143
PCI: 06:06.1 cmd <- 143
-----Original Message-----
From: YhLu
Sent: Thursday, October 21, 2004 12:11 PM
To: 'ebiederman at lnxi.com'
Cc: LinuxBIOS
Subject: RE: Freebios2 recovery progress...
I will test that on s2885.
I suspect that will need MEM enable too.
YH
-----Original Message-----
From: ebiederman at lnxi.com [mailto:ebiederman at lnxi.com]
Sent: Thursday, October 21, 2004 11:39 AM
To: YhLu
Cc: LinuxBIOS
Subject: Re: Freebios2 recovery progress...
YhLu <YhLu at tyan.com> writes:
> You can not test that in arima board. Because all device on 8131 is using
> ioapic in amd8111.
I can't test that it works but I can test that the bits are getting
set by running lspci. And that is how I tested. The bus
master bit is still getting set. I just move the location.
Eric
_______________________________________________
Linuxbios mailing list
Linuxbios at clustermatic.org
http://www.clustermatic.org/mailman/listinfo/linuxbios
More information about the coreboot
mailing list