changing the default paylolad

Frank frannk_m1 at
Thu Mar 18 10:44:01 CET 2004

Thanks I found it already ("payload") in the config file.
Actually I'm using a SIS55x based board from advantech. I built
it successfully and the code looks like it's correct. This
config is for the SIS Demo board so I have to go thru and make
sure there aren't any board specific base addresses. I am not
naive enough to think it will boot the first time so I'm going
to order a Rom Emulator with a tracing function. I have one in
mind, do you have any suggestions?
Thanks again for your help...
--- ron minnich <rminnich at> wrote:
> On Wed, 17 Mar 2004, Frank wrote:
> > Sorry for what may appear to be a stupid question but the
> answer
> > isn't really obvious since various config files are
> scattered
> > all over the place. How do I specify which file I am going
> to
> > use for the payload. I tried changing the make.base file and
> the
> > Makefile but have been unsuccessful so far. I want to use a
> text
> > file (/etc/hosts) but can't figure out where to make the
> change...
> which version again? 
> You are a bit off in the weeds so if you are on V1 start over.
> I think you 
> ought to read one of these: 
> bash-2.05b$ ls freebios/HOWTO/*
> freebios/HOWTO/ALIM1631_M1535D  freebios/HOWTO/K7SEM   
> freebios/HOWTO/SiS630
> freebios/HOWTO/EPIA             freebios/HOWTO/L440GX
> Probably the SiS630
> ron

Do you Yahoo!?
Yahoo! Mail - More reliable, more storage, less spam

More information about the coreboot mailing list