Freebios1 STPC Elite development board changes attached

[Peter Fox]

Aagh !

Ignore the following files in the archive, as they are not required:

src/include/cpu/stpc/elite/stpc_conf-notused.h
src/cpu/stpc/elite/stpc_framebuffer.inc

Ta.

-- 
Peter Fox <peter.fox at aeroflex.com>     Aeroflex Test Solutions
Principal Design Engineer                            Stevenage
Any opinions expressed above are      http://www.aeroflex.com/
not necessarily those of Aeroflex.   Tel: + 44 (0) 1438 742200

  -----Original Message-----
  From: Peter Fox [mailto:peter.fox at aeroflex.com]
  Sent: 23 February 2004 15:29
  To: Linuxbios
  Subject: Freebios1 STPC Elite development board changes attached
  
  
  Please find attached my changes to support the STPC Elite
  processor, and the mainboard/elite build configuration for
  the STPC Elite development board.
  
  These changes are for freebios1. They are mostly copies
  of the consumer-II stuff by Steve M. Gehlbach, but modified
  to remove all the graphics stuff, as the Elite has no
  graphics controller, and to add initialisation for the
  GP clock etc.
  
  I've also put in the bit-bashing SPD code for the Elite,
  though I don't use it on the development mainboard.
  
  I can run Redhat 7.1 fine (serial console only) using filo as
  the payload. This is using the 20/01/2004 snapshot for other
  files.
  
  -- 
  Peter Fox <peter.fox at aeroflex.com>     Aeroflex Test Solutions
  Principal Design Engineer                            Stevenage
  Any opinions expressed above are      http://www.aeroflex.com/
  not necessarily those of Aeroflex.   Tel: + 44 (0) 1438 742200