about etherboot and mkelfImage

[Adam Agnew]

You may also want to try mkelfImage-1.6 (in the linuxbios tree). I've
found it to work more often. I also experienced an error using the newest
mkelfImage where it would load from linuxbios but not etherboot. But that
was perhaps my binutils as well.

On Sat, 6 Sep 2003, rimy2000 wrote:

> Thanks, but
>
> 1. My Kernel is workable under Normal BIOS, it is even workable under Linux BIOS without Etherboot.
> 2. Yes, I have added them:
>
> ./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c
> onsole=/dev/ttyS0,115200n8 root=/dev/hda2"
>
> ----- Original Message -----
> From: "YhLu" <YhLu at tyan.com>
> To: "rimy2000" <rimy2000 at hotmail.com>; <linuxbios at clustermatic.org>
> Sent: Saturday, September 06, 2003 11:35 AM
> Subject: Re: about etherboot and mkelfImage
>
>
> 1. You need to verify your Kernel is workable under Normal BIOS.
> 2. when you using mkelfimage, you need add parameters for Console port and
> baud rate.
>
> YH.
>
> -----邮件原件-----
> 发件人: rimy2000 [mailto:rimy2000 at hotmail.com]
> 发送时间: 2003年9月5日 20:24
> 收件人: linuxbios at clustermatic.org
> 主题: Re: about etherboot and mkelfImage
>
> After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new
> output is
>
> Loading 172.27.4.23:vmlinuz.vo ...(ELF)...
> ............................................................................
> ............................................................................
> ............................................................................
> ............................................................................
> ............................................................................
> ............................................................................
> ............................................................................
> ............................................................................
> .......................................................................done
>
> rhine disable
>
> Firmware type: LinuxBIOS
>
> but then I received nothing from serial.
>
> Any hint?
>
> Thanks!
>
> _______________________________________________
> Linuxbios mailing list
> Linuxbios at clustermatic.org
> http://www.clustermatic.org/mailman/listinfo/linuxbios
> _______________________________________________
> Linuxbios mailing list
> Linuxbios at clustermatic.org
> http://www.clustermatic.org/mailman/listinfo/linuxbios
>