about etherboot and mkelfImage

[rimy2000]

Yes, I put.

./mkelfImage --kernel=/mnt/root/bzImage-17 --output=vmlinuz.vo --command-line="c
onsole=/dev/ttyS0,115200n8 root=/dev/hda2"


----- Original Message ----- 
From: "Adam Agnew" <agnew at cs.umd.edu>
To: "rimy2000" <rimy2000 at hotmail.com>
Cc: <linuxbios at clustermatic.org>
Sent: Saturday, September 06, 2003 11:38 AM
Subject: Re: about etherboot and mkelfImage


> 
> Did you put this on your command like "console=ttyS0,115200" (change
> 115200 for the baud you were using linuxbios at)?
> 
> On Sat, 6 Sep 2003, rimy2000 wrote:
> 
> > After I upgrade binutils to 2.14, mkelfImage 2.5 work find and the new output is
> >
> > Loading 172.27.4.23:vmlinuz.vo ...(ELF)... .......................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................done
> >
> > rhine disable
> >
> > Firmware type: LinuxBIOS
> >
> > but then I received nothing from serial.
> >
> > Any hint?
> >
> > Thanks!ÿ
> >
> > _______________________________________________
> > Linuxbios mailing list
> > Linuxbios at clustermatic.org
> > http://www.clustermatic.org/mailman/listinfo/linuxbios
> >
> 
> _______________________________________________
> Linuxbios mailing list
> Linuxbios at clustermatic.org
> http://www.clustermatic.org/mailman/listinfo/linuxbios
>