EPIA success and problem

[SONE Takeshi]

On Tue, May 06, 2003 at 02:39:09PM -0400, Adam Sulmicki wrote:
> 
> grumbe. This code should correct initalization as per ATA-3 specs.
> 
> what hard disk is this?

It's a 20GB drive from Fujitsu.

$ sudo hdparm -i /dev/hda

/dev/hda:

 Model=FUJITSU MPG3204AT E, FwRev=80B5, SerialNo=VH01P0C02R02
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=DualPortCache, BuffSize=512kB, MaxMultSect=16, MultSect=16
 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=40031712
 IORDY=yes, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes:  pio0 pio1 pio2 pio3 pio4 
 DMA modes:  mdma0 mdma1 mdma2 
 UDMA modes: udma0 udma1 *udma2 udma3 udma4 udma5 
 AdvancedPM=yes: disabled (255) WriteCache=enabled
 Drive conforms to: ATA/ATAPI-5 T13 1321D revision 1:  1 2 3 4 5


I'm thinking to replace this with a 2.5" drive.
Should I avoid Fujitsu next time? :)

-- 
Takeshi