dpilon at atipa.com
Fri Apr 18 16:43:00 CEST 2003
Removing the i2c prevented the problem.
But I will try to see where lm_sensors is messing up the bus.
On Fri, 2003-04-18 at 15:48, Jim Garlick wrote:
> Sounds very similar to a problem observed on the SuperMicro P4DPR/DPE which
> has the same winbond sensor chip. The solution was to tell lm_sensors to
> access the Winbond via ISA rather than I2C.
> I think there is also some code in the p4dpr/p4dpe linuxbios port to notice
> the memory initialization problem and work around it (e.g. wait a while
> and reset?) The details have faded but you might check the code.
> On Fri, 18 Apr 2003, Denis Pilon wrote:
> > I've got linuxbios somewhat working with the SuperMicro X5DPE-G2, but I
> > have discovered one problem.
> > If I run lm_sensors and initialize the chips, the node will not reboot.
> > It gives me a no memory error at boot.
> > Has anyone seen this? How do I start debuggin ?
> > Denis
Denis E. Pilon
Systems Integration Specialist
Atipa Technologies http://www.atipa.com/
dpilon at atipa.com (785)841-9513 x3111
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 189 bytes
Desc: This is a digitally signed message part
More information about the coreboot