Re: [SeaBIOS] Issues with ASRock E350M1

[Kevin O'Connor]

On Fri, Jun 03, 2011 at 11:55:47PM -0500, [e-mail] wrote:
> Thanks for the reply. I've spent the last week getting Coreboot
> under my control with help from CareBear.
> I'm running a patched Coreboot (latest, as of 6/3/11), and SeaBIOS
> master (as of 6/3/11).
>
> Coreboot is presenting the drives as IDE.
>
> I've attached the logs of a successful and an unsuccessful boot, as
> well as my SeaBIOS configuration - the debug level has been set to 8

The key part of the log is:

bad:
|1efd0000| powerup iobase=1420 st=7f
|1efd0000| powerup iobase=1420 st=7f
|1efd0000| ata_detect ata0-0: sc=ff sn=ff dh=ff

good:
|1efd0000| powerup iobase=1420 st=50
|1efd0000| powerup iobase=1420 st=50
|1efd0000| ata_detect ata0-0: sc=55 sn=aa dh=a0

The drive/controller is stating that the drive is not busy, but then
the drive does not respond to register reads/writes.  Thus SeaBIOS
concludes that there is no drive present.  Under normal circumstances,
the drive will report busy until it is ready to respond to register
accesses.
> -- debug output from Coreboot has been disabled, as this increases
> the overall boot time substantially.

Can the failures be correlated to boot time?  For example, if you
enable/disable debugging in coreboot+seabios, can you get it to
reliably fail or succeed?

Also, what time of controller chip is this on?

Another test - if you boot from another medium, does Linux detect your
drive even when SeaBIOS doesn't?

I'm not sure what can be done to handle a drive/controller that states
it is ready but is not.  I don't know how to distinguish that from a
drive that isn't present.

-Kevin