Kevin,

I tested many different combinations and i could not find any errors in compiling or running SeaBIOS.
Note that when I run SeaBIOS thats with coreboot on a PIII, I440BX, 83371 hardware (Nokia-IP530).

Sign-off:    Marc Bertens <mbertens@xs4all.nl>

Can you tell me why the SeaBIOS code keeps all its functions even when there are not needed?
Would it nicer to exclude whole pieces of code that are not required?

Marc


On Mon, 2011-01-24 at 09:50 +0100, Marc Bertens wrote:
Kevin,

You're right and it was easier than i expected :-)
I removed the "depends" from the Kconfig file. and that solves most of the errors.

i'll will continue testing it but I cannot test it all.

Here is the new Kconfig file for testing, I hope that you have some time too for testing this.


On Sun, 2011-01-23 at 15:39 -0500, Kevin O'Connor wrote: 
On Sun, Jan 23, 2011 at 09:01:41PM +0100, Marc Bertens wrote:
> Kevin,
> 
> I'm currently underway of fixing the Kconfig errors, already fixed
> coreboot Y/N issue. But i notice that this takes some work due to the
> way its currently coded.
> i did already boot.c, coreboot.c and ramdisk.c and there will be changes
> all over the place :-)
> 
> So this will be a mega patch 

No. No.  Kconfig must change to seabios; seabios source code should
not change to use kconfig.

-Kevin


_______________________________________________
SeaBIOS mailing list
SeaBIOS@seabios.org
http://www.seabios.org/mailman/listinfo/seabios