$ sudo flashrom -p internal -V
flashrom v0.9.6.1-r1563 on Linux 3.5.0-21-generic (i686) flashrom is free software, get the source code at http://www.flashrom.org
flashrom was built with libpci 3.1.9, GCC 4.7.1, little endian Command line (3 args): flashrom -p internal -V Calibrating delay loop... OS timer resolution is 1 usecs, 1661M loops per second, 10 myus = 10 us, 100 myus = 100 us, 1000 myus = 1017 us, 10000 myus = 10012 us, 4 myus = 4 us, OK. Initializing internal programmer No coreboot table found. DMI string system-manufacturer: "Hewlett-Packard" DMI string system-product-name: "Compaq Presario CQ60 Notebook PC" DMI string system-version: "F.26" DMI string baseboard-manufacturer: "Wistron" DMI string baseboard-product-name: "3612" DMI string baseboard-version: "09.45" DMI string chassis-type: "Notebook" Laptop detected via DMI. W836xx enter config mode worked or we were already in config mode. W836xx leave config mode had no effect. Active config mode, unknown reg 0x20 ID: fc. Please send the output of "flashrom -V" to flashrom@flashrom.org with W836xx: your board name: flashrom -V as the subject to help us finish support for your Super I/O. Thanks. ======================================================================== WARNING! You seem to be running flashrom on an unsupported laptop. Laptops, notebooks and netbooks are difficult to support and we recommend to use the vendor flashing utility. The embedded controller (EC) in these machines often interacts badly with flashing. See http://www.flashrom.org/Laptops for details.
If flash is shared with the EC, erase is guaranteed to brick your laptop and write may brick your laptop. Read and probe may irritate your EC and cause fan failure, backlight failure and sudden poweroff. You have been warned. ======================================================================== Aborting. Error: Programmer initialization failed.
-
Narcis Garcia - GiLUG