Hello all,
I need some help to get this chip MX25L12835FMI-10G manufactured by Macronix to work w/ flashrom.
I already asked for help on #flashrom IRC channel, but I was referred to ask on this mailing list. In fact, before I connected everything I asked on IRC if this chip is "already" supported, and someone from IRC did double-check it and said that the other MX25L128 chip model that IS supported is very similar and identifies itself w/ same code/id (he got this info from spreadsheet that I've linked below).
So here is my output of flashrom (I've tried both the svn version and the one shipped with ubuntu packages w/ identical results): http://paste.flashrom.org/view.php?id=2658
The chip's datasheet should be this one: http://www.macronix.com/Lists/Datasheet/Attachments/1587/MX25L12835F,%203V,%... On page 7 you can see the pin-out. The chip type I have has 16 (= 8x2) pins. There are several NC labels in the pin-out therefore I didn't connect those.
For the rest of the connections I followed this site: http://flashrom.org/Bus_Pirate (because I use a bus pirate w/ hardware version 3.6 ). The chip itself is directly attached to a pomona 5252 (SOIC-16) test clip.
What follows are some pics of my setup + chip.
Any hints and help would be very much appreciated because I am kind of stuck.
Ps. Today I discovered something interesting in the spreadsheet; the 10 (from -10g suffix) stands for 10: 104MHz . Do I need to set spispeed to a higher level b/c of this?
Thx again
- - - IMAGES - - -
Macronix MX25L12835FMI-10G chip (16 pins): http://postimg.org/image/y7ykedq6r/ Pomona soic-16 test clip 5252 : http://postimg.org/image/gqru9oum7/ Bus pirate hw version 3.6 : http://postimg.org/image/80a7zp0ub/ Test clip + chip, direction (where point is): http://postimg.org/image/koc4h655d/ Chip attached: http://postimg.org/image/4ywrbnnst/
-
Marli LI