flashrom v0.9.6.1-r1624 on Linux 2.6.39.4 (i686) flashrom is free software, get the source code at http://www.flashrom.org flashrom was built with libpci 3.0.0, GCC 4.4.3, little endian Command line (3 args): ./flashrom -p internal -V Calibrating delay loop... OS timer resolution is 1 usecs, 1611M loops per second, 10 myus = 11 us, 100 myus = 77 us, 1000 myus = 756 us, 10000 myus = 9075 us, 4 myus = 5 us, OK. Initializing internal programmer Found candidate at: 00000500-00000510 Found coreboot table at 0x00000500. Found candidate at: 00000000-000001ec Found coreboot table at 0x00000000. coreboot table found at 0xcffec000. coreboot header(24) checksum: 58f9 table(492) checksum: 135f entries: 14 Vendor ID: AOpen, part ID: DXPL Plus-U dmidecode execution unsuccessful - continuing without DMI info Found chipset "Intel ICH4/ICH4-L" with PCI ID 8086:24c0. Enabling flash write... BIOS_CNTL = 0x01: BIOS Lock Enable: disabled, BIOS Write Enable: enabled OK. The following protocols are supported: FWH. Probing for Atmel AT49LH002, 256 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for Intel 82802AB, 512 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for Intel 82802AC, 1024 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for PMC Pm49FL002, 256 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for PMC Pm49FL004, 512 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for Sharp LHF00L04, 1024 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for SST SST49LF002A/B, 256 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for SST SST49LF003A/B, 384 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for SST SST49LF004A/B, 512 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for SST SST49LF004C, 512 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for SST SST49LF008A, 1024 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for SST SST49LF008C, 1024 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for SST SST49LF016C, 2048 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content Probing for ST M50FLW040A, 512 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for ST M50FLW040B, 512 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for ST M50FLW080A, 1024 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for ST M50FLW080B, 1024 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for ST M50FW002, 256 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for ST M50FW016, 2048 kB: probe_82802ab: id1 0xff, id2 0xff, id1 parity violation, id1 is normal flash content, id2 is normal flash content Probing for ST M50FW040, 512 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for ST M50FW080, 1024 kB: probe_82802ab: id1 0xbf, id2 0x5c Probing for Winbond W39V040FA, 512 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for Winbond W39V040FB, 512 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for Winbond W39V040FC, 512 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for Winbond W49V002FA, 256 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for Winbond W39V080FA, 1024 kB: probe_jedec_common: id1 0xbf, id2 0x5c Probing for Winbond W39V080FA (dual mode), 512 kB: probe_jedec_common: id1 0xbf, id2 0x5c No EEPROM/flash device found. Note: flashrom can never write if the flash chip isn't found automatically. Restoring PCI config space for 00:1f:0 reg 0x4e