I tried with chip soldered and unsoldered. Same results.

The board is a router samknows SK-WB8

I erased uboot. Now samknows support sent me a bin file and I'm trying to write this I attach some images.

I have a bunch of spare chips to try.

The connections to the chip are made following this

https://n0wblog.blogspot.it/2017/04/dumping-flash-memory-over-spi.html

I previously tried programming with raspberry PI but it was unable to see my chip.

I have both CH341A and Raspberry Pi.

When I tried with PI i followed this

https://blackboxhacking.blogspot.it/2015/08/dump-de-memoire-flash-spi-avec.html

Where should i connect /HOLD /WP on the CH341A ?

Do you have a schematics I can follow ?

Thanks a lot

Luca

Il 5 mar 2018 21:56, "Nico Huber" <nico.h@gmx.de> ha scritto:

Hello Luca,

On 05.03.2018 19:33, Luca Bacci Bonotti wrote:
> Hi I need help with flashrom . I'm unable to write a firmware using CH341A
> programmer, test clip pomona 5252 .

flashing in-system (ISP) is sometimes a very delicate procedure. How
and if it will work, depends on many things: 1. is the board designed
for ISP; if, follow the manual; if not 2. how do you power the flash
chip? through the board's regular power supply (strongly advised)? or
through the ch341a (discouraged unless you know exactly what you are
doing)? 3. are all input pins of the flash chip in a defined state?
(e.g. don't forget /HOLD and /WP). See also [1] and [2].

> The EEPRom I'm trying to write is
> S25FL128SAGMFI000.

Regarding ISP, the board the chip is soldered to matters more than the
chip. What board is it?

Hope that helps,
Nico

[1] https://flashrom.org/ISP
[2] https://flashrom.org/Common_problems