I have a TUMPA Lite edition it is FTDI Based Board similar to TUMPA/FT232H, but single channel:
http://www.tiaowiki.com/w/TIAO_USB_Multi_Protocol_Adapter_Lite_User's_Manual

You can build one from upper link, or buy cheap on ebay.

And I added this to ft2232_spi.c

--- ../flashrom/ft2232_spi.c 2013-09-17 19:43:16.000000000 +0200
+++ ft2232_spi.c 2014-01-24 11:57:49.000000000 +0100
@@ -43,6 +43,7 @@
 #define FTDI_FT4232H_PID 0x6011
 #define FTDI_FT232H_PID 0x6014
 #define TIAO_TUMPA_PID 0x8a98
+#define TIAO_TUMPA_LITE_PID   0x8a99
 #define AMONTEC_JTAGKEY_PID 0xCFF8
 
 #define GOEPEL_VID 0x096C
@@ -62,6 +63,7 @@
  {FTDI_VID, FTDI_FT4232H_PID, OK, "FTDI", "FT4232H"},
  {FTDI_VID, FTDI_FT232H_PID, OK, "FTDI", "FT232H"},
  {FTDI_VID, TIAO_TUMPA_PID, OK, "TIAO", "USB Multi-Protocol Adapter"},
+        {FTDI_VID, TIAO_TUMPA_LITE_PID, OK, "TIAO", "USB Multi-Protocol Adapter Lite"},
  {FTDI_VID, AMONTEC_JTAGKEY_PID, OK, "Amontec", "JTAGkey"},
  {GOEPEL_VID, GOEPEL_PICOTAP_PID, OK, "GOEPEL", "PicoTAP"},
  {FIC_VID, OPENMOKO_DBGBOARD_PID, OK, "FIC", "OpenMoko Neo1973 Debug board (V2+)"},
@@ -208,6 +210,10 @@
  /* Interface A is SPI1, B is SPI2. */
  ft2232_type = TIAO_TUMPA_PID;
  channel_count = 2;
+ } else if (!strcasecmp(arg, "tumpalite")) {
+ /* Only one channel is used on lite edition */
+ ft2232_type = TIAO_TUMPA_LITE_PID;
+ channel_count = 1;
  } else if (!strcasecmp(arg, "busblaster")) {
  /* In its default configuration it is a jtagkey clone */
  ft2232_type = FTDI_FT2232H_PID;

works as advertised. 

BRGDS, Jadran Puharic