2012/10/27 Stefan Tauner
<stefan.tauner@student.tuwien.ac.at>
Hello Philipp,
thanks for sharing.
On Sat, 27 Oct 2012 15:44:51 +0200
Philipp Wiesner <
wiesnerph@fh-bingen.de> wrote:
> I had to make
> some customizations to ft2232.c add support for this programmer. I had to
> build a cable which connects the JTAG interface with the on-board SF100
> interface.
hardware modifications necessary for the TI board nor the iEi
mainboard, right?
Your assumptions are correct. No hardware modifications were made, I just had to jumper the TI board appropriately (basically disconnecting the MCU from the JTAG port).
> I like to share as much of the knowledge I acquired as possible with the
> community. The least thing I can do is send a patch with my modifications
> for the TI development board. I still need to read the instructions on how
> to prepare and send patches as I haven't done this in a long time.
How did you obtain the flashrom source (file archive, subversion,
git...)? Depending on that the way to obtain a usable diff/patch vary a
lot. If you need further help you can also ask us on our IRC channel,
#flashrom on freenode, available also via this website:
http://webchat.freenode.net/?channels=flashrom&uio=d4
I based my modifications on the last release, but as these are just a few additional lines to the sources, I could easily base those on trunk or any other revision. I'll see how far I can get, I'll be gladly asking for help then.
--
Kind regards/Mit freundlichen Grüßen, Stefan Tauner