Hi!

Just wanted to report some undocumented stuff.

I've been working on 3com nic device:
02:00.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 30) which seems to be reported as working on wiki - and it does ;)

First thing:
Winbond W29EE011 (128k, parallel) works well, but not auto (needs to be forced by '-c') - yes, i know why.
I'm not sure if it was while programming this one or Pm..., but it dropped message about 'retrying to flash', and it worked well after all.

Second:
PMC "Pm29F002T" (256 kB, Parallel) works fine until write (since it is too big for 3com [256 vs 128 kB]).
I'll try to read content of this one after erase command.
Intersting thing: i write a bit modified oryginal bios, i changed one letter about the end of 256kb:
Oryginal: BOOT
Modifed: LOOT
Write&Read: @OOT

Another suggestion of mine: meybe add to PCI-devices list maximal chip size support?

All files (including rom's (un)modified and reflased&read) are avialable here: http://www.e-san.info/Go!/deeper!/Flashrom/13.10.21/ .

Hope it is useful report.

Best regards!

--
[ e-San.info | San@plusnet.pl ]