tail: log: file truncated
flashrom v0.9.9-r1954 on Linux 4.17.10 (x86_64)
flashrom was built with libpci 3.5.2, GCC 6.3.0 20170221, little endian
Command line (8 args): flashrom -p buspirate_spi:dev=/dev/ttyUSB0,spispeed=250k -c SST25VF512(A) -w sernum_eeprom -o log
Calibrating delay loop... OS timer resolution is 1 usecs, 2792M loops per second, 10 myus = 11 us, 100 myus = 122 us, 1000 myus = 1030 us, 10000 myus = 10032 us, 4 myus = 4 us, OK.
Initializing buspirate_spi programmer
Detected Bus Pirate hardware v3a
Detected Bus Pirate firmware 5.10 ("v5.10")
Using SPI command set v2.
SPI speed is 250kHz
Raw bitbang mode version 1
Raw SPI mode version 1
The following protocols are supported: SPI.
Probing for SST SST25VF512(A), 64 kB: probe_spi_rems: id1 0xbf, id2 0x48
Found SST flash chip "SST25VF512(A)" (64 kB, SPI) on buspirate_spi.
Chip status register is 0x0c.
Chip status register: Block Protect Write Disable (BPL) is not set
Chip status register: Auto Address Increment Programming (AAI) is not set
Chip status register: Block Protect 3 (BP3) is not set
Chip status register: Block Protect 2 (BP2) is not set
Chip status register: Block Protect 1 (BP1) is set
Chip status register: Block Protect 0 (BP0) is set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
Some block protection in effect, disabling... disabled.
Reading old flash chip contents... done.
Erasing and writing flash chip... Trying erase function 0... 0x000000-0x000fff:EW