
Feb. 1, 2015
3:56 a.m.
On Fri, 26 Dec 2014 20:53:47 -0500 Justin Chevrier <jchevrier@gmail.com> wrote:
Hi Stefan,
It seems you're correct. Signed off is below.
Signed-off-by: Justin Chevrier <jchevrier@gmail.com>
Does the option to set voltage=0V really make sense? But since this is even possible... I would rather set it to 0V at shutdown. If that turns off the drivers completely it might be very useful while doing in-circuit programming because the programmer could remain attached even when the target is running. Why do we restrict the levels to 3 values although the API seems to allow to transmit a much finer resolution? What does the hardware actually do with these values? -- Kind regards/Mit freundlichen Grüßen, Stefan Tauner