Okay, I'm seeing it better now and it isn't removing the block protection.

On Tue, Dec 12, 2017 at 10:23 AM, Lamont Dean <lamont.dean@imsar.com> wrote:
Hello,

Flashrom can find the Intel I210 NIC SPI connected to the SST25VF040B flash chip and seems to program but fails to verify and gave me this email to write to about it.  The output is included below.  Before and after a power cycle the Intel I210 still says its in its unprogrammed state.

I'd like to program a Microchip SST26VF016B flash in place of the ...25VF040... but its not on the list so I'm going through the comments I found on the wedsite Design Guide.  I'm new to Linux and things so we'll see how it goes.

Any help you can offer would be greatly appreciated.

Thanks,

LaMont Dean
Hardware Engineer
ImSAR, LLC.

...flashrom> sudo flashrom -VVVV -p nicintel_spi:pci=01:00.0 -c SST25VF040B -w Dev_Start_I210_Copper_NOMNG_4Mb_A2_3.25_0.03.bin
flashrom v0.9.9-r1954 on Linux 4.4.38-tegra (aarch64)
flashrom is free software, get the source code at https://flashrom.org

flashrom was built with libpci 3.3.1, GCC 5.4.0 20160609, little endian
Command line (7 args): flashrom -VVVV -p nicintel_spi:pci=01:00.0 -c SST25VF040B -w Dev_Start_I210_Copper_NOMNG_4Mb_A2_3.25_0.03.bin
Calibrating delay loop... OS timer resolution is 1 usecs, 2531M loops per second, 10 myus = 10 us, 100 myus = 100 us, 1000 myus = 1001 us, 10000 myus = 10022 us, 4 myus = 4 us, OK.
Initializing nicintel_spi programmer
Found "Intel Unprogrammed i210 Gigabit Ethernet Controller" (8086:1531, BDF 01:00.0).
===
This PCI device is UNTESTED. Please report the 'flashrom -p xxxx' output
to flashrom@flashrom.org if it works for you. Please add the name of your
PCI device to the subject. Thank you for your help!
===
PCI header type 0x00
Requested BAR is of type MEM, 32bit, not prefetchable
PCI header type 0x00
Requested BAR is of type MEM, 32bit, not prefetchable
page_size=1000
pre-rounding:  start=0x0000000050800000, len=0x1000, end=0x0000000050801000
post-rounding: start=0x0000000050800000, len=0x1000, end=0x0000000050801000
The following protocols are supported: SPI.
Probing for SST SST25VF040B, 512 kB: programmer_map_flash_region: mapping SST25VF040B from 0x00000000fff80000 to 0x0000000000000000
RDID returned 0xbf 0x25 0x8d. probe_spi_rdid_generic: id1 0xbf, id2 0x258d
Found SST flash chip "SST25VF040B" (512 kB, SPI) on nicintel_spi.
Chip status register is 0x1c.
Chip status register: Block Protect Write Disable (BPL) is not set
Chip status register: Auto Address Increment Programming (AAI) is not set
Chip status register: Block Protect 3 (BP3) is not set
Chip status register: Block Protect 2 (BP2) is set
Chip status register: Block Protect 1 (BP1) is set
Chip status register: Block Protect 0 (BP0) is set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
Resulting block protection : all blocks
programmer_unmap_flash_region: unmapped 0x0000000000000000
programmer_map_flash_region: mapping SST25VF040B from 0x00000000fff80000 to 0x0000000000000000
Some block protection in effect, disabling... Block protection could not be disabled!
Chip status register is 0x1c.
Chip status register: Block Protect Write Disable (BPL) is not set
Chip status register: Auto Address Increment Programming (AAI) is not set
Chip status register: Block Protect 3 (BP3) is not set
Chip status register: Block Protect 2 (BP2) is set
Chip status register: Block Protect 1 (BP1) is set
Chip status register: Block Protect 0 (BP0) is set
Chip status register: Write Enable Latch (WEL) is not set
Chip status register: Write In Progress (WIP/BUSY) is not set
Resulting block protection : all blocks
Reading old flash chip contents... done.
Erasing and writing flash chip... Trying erase function 0... 0x000000-0x000fff:W, 0x001000-0x001fff:S, 0x002000-0x002fff:W, 0x003000-0x003fff:W, 0x004000-0x004fff:W, 0x005000-0x005fff:W, 0x006000-0x006fff:W, 0x007000-0x007fff:W, 0x008000-0x008fff:W, 0x009000-0x009fff:W, 0x00a000-0x00afff:W, 0x00b000-0x00bfff:W, 0x00c000-0x00cfff:W, 0x00d000-0x00dfff:W, 0x00e000-0x00efff:W, 0x00f000-0x00ffff:W, 0x010000-0x010fff:W, 0x011000-0x011fff:W, 0x012000-0x012fff:W, 0x013000-0x013fff:W, 0x014000-0x014fff:W, 0x015000-0x015fff:W, 0x016000-0x016fff:W, 0x017000-0x017fff:W, 0x018000-0x018fff:W, 0x019000-0x019fff:W, 0x01a000-0x01afff:W, 0x01b000-0x01bfff:W, 0x01c000-0x01cfff:W, 0x01d000-0x01dfff:W, 0x01e000-0x01efff:W, 0x01f000-0x01ffff:W, 0x020000-0x020fff:W, 0x021000-0x021fff:W, 0x022000-0x022fff:W, 0x023000-0x023fff:W, 0x024000-0x024fff:W, 0x025000-0x025fff:W, 0x026000-0x026fff:W, 0x027000-0x027fff:W, 0x028000-0x028fff:W, 0x029000-0x029fff:W, 0x02a000-0x02afff:W, 0x02b000-0x02bfff:W, 0x02c000-0x02cfff:W, 0x02d000-0x02dfff:W, 0x02e000-0x02efff:W, 0x02f000-0x02ffff:W, 0x030000-0x030fff:W, 0x031000-0x031fff:W, 0x032000-0x032fff:W, 0x033000-0x033fff:W, 0x034000-0x034fff:W, 0x035000-0x035fff:W, 0x036000-0x036fff:W, 0x037000-0x037fff:W, 0x038000-0x038fff:S, 0x039000-0x039fff:S, 0x03a000-0x03afff:S, 0x03b000-0x03bfff:S, 0x03c000-0x03cfff:W, 0x03d000-0x03dfff:W, 0x03e000-0x03efff:W, 0x03f000-0x03ffff:S, 0x040000-0x040fff:S, 0x041000-0x041fff:S, 0x042000-0x042fff:S, 0x043000-0x043fff:S, 0x044000-0x044fff:S, 0x045000-0x045fff:S, 0x046000-0x046fff:S, 0x047000-0x047fff:S, 0x048000-0x048fff:S, 0x049000-0x049fff:S, 0x04a000-0x04afff:S, 0x04b000-0x04bfff:S, 0x04c000-0x04cfff:S, 0x04d000-0x04dfff:S, 0x04e000-0x04efff:S, 0x04f000-0x04ffff:S, 0x050000-0x050fff:S, 0x051000-0x051fff:S, 0x052000-0x052fff:S, 0x053000-0x053fff:S, 0x054000-0x054fff:S, 0x055000-0x055fff:S, 0x056000-0x056fff:S, 0x057000-0x057fff:S, 0x058000-0x058fff:S, 0x059000-0x059fff:S, 0x05a000-0x05afff:S, 0x05b000-0x05bfff:S, 0x05c000-0x05cfff:S, 0x05d000-0x05dfff:S, 0x05e000-0x05efff:S, 0x05f000-0x05ffff:S, 0x060000-0x060fff:S, 0x061000-0x061fff:S, 0x062000-0x062fff:S, 0x063000-0x063fff:S, 0x064000-0x064fff:S, 0x065000-0x065fff:S, 0x066000-0x066fff:S, 0x067000-0x067fff:S, 0x068000-0x068fff:S, 0x069000-0x069fff:S, 0x06a000-0x06afff:S, 0x06b000-0x06bfff:S, 0x06c000-0x06cfff:S, 0x06d000-0x06dfff:S, 0x06e000-0x06efff:S, 0x06f000-0x06ffff:S, 0x070000-0x070fff:S, 0x071000-0x071fff:S, 0x072000-0x072fff:S, 0x073000-0x073fff:S, 0x074000-0x074fff:S, 0x075000-0x075fff:S, 0x076000-0x076fff:S, 0x077000-0x077fff:S, 0x078000-0x078fff:S, 0x079000-0x079fff:S, 0x07a000-0x07afff:S, 0x07b000-0x07bfff:S, 0x07c000-0x07cfff:S, 0x07d000-0x07dfff:S, 0x07e000-0x07efff:S, 0x07f000-0x07ffff:S
Erase/write done.
Verifying flash... FAILED at 0x00000000! Expected=0x00, Found=0xff, failed byte count from 0x00000000-0x0007ffff: 0x3527c
Your flash chip is in an unknown state.
Please report this on IRC at chat.freenode.net (channel #flashrom) or
mail flashrom@flashrom.org, thanks!
programmer_unmap_flash_region: unmapped 0x0000000000000000